Installation Instructions for Carbon Fiber Rear Spoiler Trunk Lid Diffuser Adro Style

Installation Instructions for Carbon Fiber Rear Spoiler Trunk Lid Diffuser Adro Style: Note: It is recommended to have this installation performed by a professional or someone with experience in automotive modifications. Tools needed: – Socket wrench set – Screwdriver (Phillips and flathead) – Tape measure – Adhesive promoter (optional) – Alcohol wipes (optional) Installation Steps: 1. Preparation: – Ensure your vehicle is parked on a flat surface and engage the parking brake. – Clean the trunk lid thoroughly with soap and water to remove any dirt or debris. 2. Test Fit: – Before proceeding with the installation, perform a test fit of the Carbon Fiber Rear Spoiler Trunk Lid Diffuser Adro Style on your vehicle’s trunk lid. – Align the diffuser with the contours of the trunk lid, ensuring proper placement and fitment. – Make any necessary adjustments to ensure a precise fit. 3. Installation: – Using a tape measure, measure and mark the exact center of the trunk lid. – Carefully align the Carbon Fiber Rear Spoiler Trunk Lid Diffuser Adro Style with the center mark on the trunk lid. – Temporarily secure the diffuser in place using masking tape or painter’s tape to hold it in position. 4. Mounting: – With the diffuser properly aligned and taped in place, start mounting it to the trunk lid. – Using a socket wrench and the provided hardware, attach the diffuser to the trunk lid using the pre-drilled holes. – Tighten the screws securely but avoid over-tightening to prevent damage to the carbon fiber. 5. Optional Adhesive: – If desired or recommended by the manufacturer, apply adhesive promoter to the mounting surface of the trunk lid. – Apply a thin, even layer of automotive-grade adhesive to the underside of the diffuser. – Carefully align the diffuser with the taped position on the trunk lid and press firmly to ensure proper adhesion. – Follow the adhesive manufacturer’s instructions for curing and drying times. 6. Final Adjustment: – Double-check the alignment and fitment of the Carbon Fiber Rear Spoiler Trunk Lid Diffuser Adro Style. – Make any necessary adjustments to ensure it is centered and sits flush with the trunk lid. – Remove any tape used for temporary positioning. Congratulations! You have successfully installed the Carbon Fiber Rear Spoiler Trunk Lid Diffuser Adro Style on your vehicle. Enjoy the enhanced aesthetics and unique sporty appearance it brings to your vehicle’s rear end. Please refer to the manufacturer’s specific instructions for any additional care or maintenance recommendations to ensure the longevity of your carbon fiber diffuser.